![]() ![]() The following chart shows the default hotkey combinations. It is suggested to use the Select button as the hotkey. The Hotkey button enables you to press it in combination with another button to access functions such as saving, loading, and exiting in emulators. Go ahead and configure your controller as per the diagram below: When you get to OK press the button you have configured as "A". Hold down any button on your keyboard or gamepad and the name will appear at the bottom and then open up into a configuration menu.įollow the onscreen instructions to configure your gamepad, if you run out of buttons just hold down a button to skip each unused button. The setup script will guide you through pairing the buttons. ![]() HOLD A BUTTON ON YOUR DEVICE TO CONFIGURE IT. ![]() After a minute or so, EmulationStation will launch and ask you to configure your controller, you will see a screen that says: “WELCOME. Switch on the power to your Raspberry Pi. How to Configure Your RetroPie Controller by Alan Pfahler on AugT19:13:36+00:00 ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |